![anilam series 1100 retrofit anilam series 1100 retrofit](https://i.ytimg.com/vi/Q1cH3Gwlytc/hqdefault.jpg)
Is this because I have a early version, or am I missing something more fundamental ? I'm sure some of these issues must have been resolved before, and it would be great to get this code to run as intended. 71, Anilam 3x conversational, ANILAM, SERIES 1100, ANILAM SERIES 1100, NO, NO. The console message was : 'Error 'Stop spindle before Fwd / Rev command.' I had a similar issue at Line 34, though on the next attempt, it ran the program past this point unchallenged. this consistently gave a console message of 'Error : Must stop spindle before tool change'. Whilst the above lines were missing, the following line halted the program run, which I could not seem to restart :
![anilam series 1100 retrofit anilam series 1100 retrofit](http://www.illianaindtech.com/PartsBook3-14-14/Anilam-Service/docs/1100GUID_files/image005.jpg)
This includes the following (and any repeats) :
Anilam series 1100 retrofit code#
The oddities mainly consist of code lines that did not appear on my mill console (despite being transmitted) I am guessing they could not be translated. There seem to be a couple of show stoppers for me in the generated code.įrom the sample code, (Oct 2017) the machine did not load the lines for Arc Cw, or Arc Ccw, they are missing, not even a blank line shown. Anilam Notice Programmation et de Fonctionnement CNC 3300. Continue with reading or go to download page.
Anilam series 1100 retrofit manual#
Anilam 1100M Programming Manual CNC Three Axis. Later I came across the 'Sample' code in the Autodesk CAM posts section, and downloaded that, and fed it to the mill, getting a very similar result. CNC Manual / ANILAM / Anilam 1100M Programming Manual CNC Three Axis. I was very pleased that the mill seemed to accept it, and ran some of it, though there were some lines missing.
![anilam series 1100 retrofit anilam series 1100 retrofit](http://www.illianaindtech.com/PartsBook3-14-14/Anilam-Service/docs/1100GUID_files/image007.jpg)
With the help of a pal to try it out, we drew a simple cube with rounded corners and a hole machined in the centre and generated a CAM file for the mill, using Anilam Conversational post processor. It is brilliant that the Fusion360 has a CAM interface for so many machines including Anilam Conversational. At the bottom of the welcome screen it says Version 6.42A. It has no hard drive, so I load larger programs via DNC (- does anyone know if it is possible to retrofit a hard drive ?). Hello, I have recently purchased an Ajax three axis cnc mill with Anilam 1100M CNC controls.